Overview

To use Policy-Based Routing (PBR), you should configure the interfaces on the Exinda appliance with the appropriate settings, using either the Exinda Web UI or the CLI.

This article provides step-by-step instructions on how to configure an out-of-path Exinda appliance for PBR on two subnets using the CLI.

Process

1. On the out-of-path Exinda appliance # 1, launch the Exinda web UI.
   1. In the browser address field, type https://<Exinda_IP_address>
   2. Enter the username and password for the appliance.
   3. Click Login.
      • The Exinda web UI displays.
   4. Ensure you are in Advanced mode.
2. Click Configuration > System > Tools> Console.
3. Type the appliance username and password at the prompts.
   • To enter the privileged EXEC (enable) mode, at the prompt run the following command:
     
     

     hostname > enable

   • The hostname # prompt appears.
   • To enter the configuration (config) mode, at the prompt run the following command:
     
     

     hostname # configure terminal

   • The hostname (config)# prompt appears.
4. Remove the BR10 bridge:
   
   

   hostname (config)# no bridge BR10 enable

5. Set the IP address and netmask of the out-of-path Exinda appliance:
   
   

   hostname (config)# interface eth11 ip address 10.10.10.2 /24

6. Identify the interface to be used for policy-based routing:
   
   

   hostname (config)# pbr interface eth11

7. Set the IP address of the router:
   
   

   hostname (config)# pbr interface ip next-hop 10.10.20.1

8. To set the parameters of eth11, type the following commands:
   
   

   hostname (config)# no interface eth11 dhcp
   
   hostname (config)# interface eth11 display
   
   hostname (config)# interface eth11 duplex auto
   
   hostname (config)# interface eth11 mtu 1500
   
   hostname (config)# no interface eth11 shutdown
   
   hostname (config)# interface eth11 speed auto

9. Repeat the above steps on the out-of-path Exinda appliance #2.

Related Article

Configuring a Router for Policy-Based Routing With Two Subnets