Articles

ExOS Solution - Software - 6.4.x

• Changing Network Object Location Causing Page Timeouts with Squid Error while Edge Cache is Enabled

  SummaryWhen using an 'inherit' network object and sending traffic to an 'internal' network object, if the 'inherit' object is changed to 'internal' as well, internet pages requested by hosts in the ne...

• Changing Speed, Duplex or MTU of Exinda NIC via CLI

  Overview This article provides information that relates to the changes of speed, duplex, or MTU of an Exinda device via CLI (command-line interface).    Information Speed, duplex, or MTU (Maximum Tran...

• Changing the Next Boot Partition via CLI

  Overview This article provides relevant information to keep in mind when changing the next boot partition via CLI (command-line interface).   Information Changing the partition that is going to boot n...

• Changing Virtualization Ports

  Overview When using the Exinda as a virtualization platform, it is possible to change the interface that virtualization uses for communication. This article provides general information on that matter...

• 'Allow' ACL Configuration in Cisco ASA Firewall for TCP Options 30 & 230

  Overview Sometimes, when doing acceleration, it is possible for other devices to strip off information that the remote Exinda needs to successfully accelerate traffic. Cisco ASA Firewalls are known to...

• Configuring IP Addresses on a New Exinda Appliance

  Overview This article provides instructions to configure an IP address on a new Exinda device.   Process Power on the Exinda device. Make sure all the wiring is intact, and Exinda has access to the In...

• Concurrent Connections Seen Permanently Increasing

  SummaryIn the Exinda appliance, the 'Concurrent Connections' graph show the number of total connections through the device. This number increases and decreases by using internal stats of the number of...

• Configuring policies based on schedules

  SummaryIt is possible to use schedules in order to create different policies for the same traffic, based on different times of day OverviewThe Exinda allows for configuring policies in the optimizer t...

• Congestion Control Algorithms in TCP Acceleration Between Appliances

  Overview This article outlines the differences between the different congestion control algorithms offered on the appliance for acceleration.   Information Mostly, these algorithms are improvements in...

• Error: "Daily granularity for Subnet statistics is only available for the past 2 weeks" in Customer Reports for Subnets

  Overview When trying to create a custom report for subnets, if the range is greater than that of two weeks prior, the following error may occur: Error: Daily granularity for Subnet statistics is only ...