Articles

Issue/Error Messages, Reference and/or NonAdmin HowTo's about: CLI Applications Backup Database Network Optimization

• Exinda CLI: Web UI and Web Proxy

  Overview   This article provides information regarding the Exinda CLI command web. You can use the web command to configure the web user interface (Web UI).   Information   NOTE:  The following syntax...

• Traffic Shaping Queue Modes

  Overview   Every Exinda appliance needs to maintain a queue of packets for each policy within their respective virtual circuits when shaping traffic as specified by the policies. This article describe...

• Configuring Bridges in NIC Settings Page

  Overview   This article provides information regarding the bridge settings in the NIC settings page and the respective configurations for the current running mode and failover mode of the bridges (e.g...

• NIC Settings

  Overview   This article provides information regarding the NIC (Network Interface Card) settings page, which is used to set the following: Speed, duplex, and MTU of the system NICs. The behavior of th...

• Accessing the Command Line Interface

  Overview   The Serial Console Interface is a tool which connects to the Exinda appliance's Command Line Interface (CLI) from the Web UI. This tool connects to the appliance via the web interface and d...

• Running the CLI Jumpstart Wizard

  Overview   When you log in to the CLI (Command Line Interface) for the first time, you are presented with the option to run the CLI Jumpstart wizard. This is a guided wizard that helps with the initia...

• Enabling WCCP on the Exinda Appliance

  Overview An Exinda appliance can accelerate traffic routed using the WCCP v2. You can use this topology when you want application acceleration, but do not wish to install the Exinda appliance inline. ...

• Directing Traffic With Policy-Based Routing

  Overview Using PBR, you can deploy your Exinda appliance in the network out-of-path but retain the in-path optimization capabilities. To achieve this, you should configure the router with the policy t...

• Configuring an Exinda Appliance for Policy-Based Routing Using CLI

  Overview To use PBR, you should configure the interfaces on the Exinda appliance with the appropriate settings, using either the Exinda web UI or the CLI. This article provides step-by-step instructio...

• Policy-Based Routing With Two Subnets for Failover and Redundancy

  Overview You can deploy PBR on two subnets serviced by their own Exinda appliances. The configuration detailed below re-routes the traffic from one Exinda appliance to another in case of hardware fail...